ecoplumber.net - recycling hot water recirculation systems

Often used to circulate domestic hot water so that a faucet will provide hot water instantly upon demand. In regions where water conservation issues are rising in importance with a rapidly expanding population, and a record economic expansion that has consumers looking for comfort, so-called Hot Water Recirculation (HWR) pumps can aid in water conservation at a relatively small expense in added energy use. In typical one-way plumbing without a circulation pump, water is simply piped from the water heater through the pipes to the tap. Once the tap is shut off, the water remaining in the pipes cools producing the familiar wait for hot water the next time the tap is opened. By adding a circulator pump and constantly circulating a small amount of hot water through the pipes from the heater to the furthest fixture and back to the heater, the water in the pipes is always hot, and no water is wasted during the wait. The tradeoff is the energy wasted in operating the pump and the heat lost from the constantly-hot pipes. Thermal insulation applied to the pipes helps mitigate this second loss and minimize the amount of water that must be pumped to keep hot water constantly available.

The traditional hot water recirculation system uses a dedicated return line from the point of use located farthest from the hot water tank back to the hot water tank. In homes where this return line was not installed the cold water line is used as a return line with a temperature control device closing the connection between the hot and cold lines at a set temperature. Compared to a dedicated return line, using the cold water line as a return has the disadvantage of heating the cold water pipe (and the contained water). Technological advancements within the industry allowed for incorporating timers to limit the operations during specific hours of the day to reduce energy waste by only operating when occupants where likely to use hot water. Additional advancements in technology include pumps which cycle on and off to maintain hot water temperature versus a continuously operating pump which consumes more electrical energy. Utilizing "normally closed" crossover valves have been shown to further reduce energy consumption by preventing undesired siphoning of water from a hot water line during cold water usage which lowers the cold water lines water pressure allowing the higher pressured water in the hot water lines to pass through a "normally open" crossover valve increasing the energy demand on the water heater.